Need help?Do you have a question about the Blonder tongue Broadband and is the answer not in the manual?
General| Brand | Blonder tongue |
|---|---|
| Model | Broadband |
| Category | Modem |
| Language | English |
Comparison of headend product specifications including modulators, processors, and demodulators.
Guide to configuring switch settings for AP/AD-1 products.
Details on the ATSC/QAM Demodulator unit's front and rear panels, and operating modes.
Information on the Agile QAM Modulator unit, its features, and interactive sequence.
Explanation of the ATSC to QAM Transcoder unit, its applications, and front/rear panels.
Overview of the Digital to Analog Processor unit, its features, and front/rear panels.
Description of the Modular QPSK/QAM Transcoder, its features, and panel layout.
Details on QPSK/QAM Transcoder modes, output levels, and factory reset.
Interface between trunk data network and coax, supporting up to 64 MPOs.
Replaces ordinary TV outlets with TV and network connections.
Discusses installation methods, case studies, and signal settings.
Application for viewing link stat settings of IO/MPO components.
Main screen for managing MPOs, RF data, and software updates.
Adjusting RF parameters for MPG downstream and upstream.
Steps to verify IO functionality and troubleshoot common issues.
Information on VMI interdiction products.
Details on TV Channel Blocker products.
Features of the parental controlled TV channel blocker.
Overview of SMI products and former naming.
Information on AMT interdiction units.
Describes oscillator configurations for generating jamming signals.
Formula for calculating cross modulation in amplifiers.
Formula for calculating composite triple beat in amplifiers.
Formula for calculating single second order distortion.
Formula for calculating composite second order distortion.
Formula for calculating composite intermodulation noise.
Formulas for carrier to hum modulation ratio.
Formulas for carrier to noise ratio calculation.
Formulas related to TVRO antenna calculations.
Equations for calculating antenna pointing angles.
Formula for acceptable peak-to-valley deviation in amplifier cascades.
Chart and example for calculating amplifier cascade effects.
Summary of FCC specifications for CATV systems.
Method for assessing cable plant leakage integrity.
Table of maximum leakage levels by channel and voltage.
Summary of FCC rules and regulations for CATV systems.
FCC rules for RF signal leakage limits.
Diagram relating QAM signal-to-noise ratio to bit-error rate.
Definition and calculation of QAM modulation error ratio.
To Next Page
