Chapter 10 CIT Testing
Input “*#84666*#” in the standby mode.
1. Version: Confirm the firmware version.
2. Echo Loop: Receiver shall produce sound when blowing over the mic.
3. Keypad: Press every button on the handset until the screen is clear.
4. Vibrator：Press “start” then the vibration shall start.
5. Loud SPK: Press “start” the speaker shall work.
6. Ringtone: Press “start” the ringtone shall be played.
7. LED：Press “OK” to test the LED.
8. LCD: Select “Auto Display” LCD shall perform the self-testing.
9. Receiver：Press ”start” the receiver shall produce sound.
10. Camera: Menu- Camera, test the capture and shooting, no need to save.
To Previous Page
Loading...
