WARRANTY
Don’t worry. Your BluDento BLT-HD is covered under our warranty. For warranty
information please visit:http://bludento.com/contact-bludento/
www.bludento.com
eshop@bludento.com
PRODUCT SAFETY
When used in the directed manner, this unit has been designed and manufac-
tured to ensure your personal safety. Improper use of this product can result
in potential electrical shock or fire hazards. Please read all safety and operat-
ing instructions carefully before installation and use. Keep these instructions
handy for future reference.
Users of this product are cautioned not to make modifications or changes
that are not approved by BluDento, Inc. Doing so may void the compliance of
this product and may result in the loss of the user’s authority to operate the
equipment.
SAFETY INSTRUCTIONS
Keep product dry to avoid affecting the interior circuitry of the product.
High temperature will shorten the life of electronic device.
Don’t expose to extreme temperatures, it may damage the internal
circuit board.
Don’t drop the product.
Don’t put the product in direct sunlight or place in hot areas.
Don’t use chemical or detergent to clean the product.
Don’t take the product apart or the warranty will be voided.
Using the product at excessive volumes may cause permanent hearing
damage. You can get the most out of your equipment and enjoy great
audio performance even at safe levels.
Due to isolating characteristic of the product, do not use the product at
excessive volume while driving or in any other activity where failure to hear
surrounding sounds could be dangerous.
TECHNICAL SPECIFICATIONS
Bluetooth Version: 5.0 with aptX HD
Supported Codecs: aptX, aptX Low Latency, aptX HD, SBC, AAC,
MP3, FLAC, TFF.
Bluetooth Range: 30 meters, 100 feet
Input: Bluetooth
Outputs: Stereo Analog RCA; Digital Optical & Coaxial (SPDIF)
Input Power: Power Requirement: DC 5V (USB), 200mA (Min), 3A (Max)
Output Voltage: 2.1 Volts RMS
Output Impedance: 57 Ohms
D/A Converter: TI PCM5102A
Frequency Response: 10Hz - 20kHz (+/- 0.5dB)
Signal to Noise Ratio: 112dB
Total Harmonic Distortion: + Noise < 0.02%
Latency: ~30 milliseconds (MS)
Enclosure: Aluminum + ABS
To reduce the risk of electric shock
Do not remove cover (or back).
No user-serviceable parts inside.
Refer servicing to qualified service personnel.
9.9cm
2.5cm
7.5cm
Included Accessories:
• RCA - RCA Audio Cable
• RCA - 3.5mm Audio adapter
• USB - micro USB Cable
• TOSLINK optical audio cable
• User Guide
NOT included:
• Coaxial audio cable
• Power plug
DESIGNED IN AUSTRALIA – MADE IN CHINA BLUDENTO INC.
©2019 BluDento, Inc. All Rights Reserved.
The Bluetooth word mark and logos are registered
Trademarks owned by Bluetooth SIG, Inc.
The aptX mark and the aptX logo are trademarks of Qualcomm or one of
its group companies and may be registered in one or more jurisdictions.
All other trademarks and logos are property of their respective owners.
BLT-HD-Manual-2019.indd 2 22/2/19 12:44 pm
To Next Page
Loading...
