Need help?Do you have a question about the Blue Coat SG200 200 A and is the answer not in the manual?
Details on how to unpack the SG200 appliance and verify package contents.
Description of the front-panel LEDs for the SG200 appliance, including Power, Disk Drive, Adapter Port, and System LEDs.
Identification and description of the components located on the back of the SG200 appliance.
Instructions for installing the SG200 appliance on a shelf, wall, or in an equipment rack.
Steps to power on the SG200 appliance and verify the Power LED status after booting.
Introduces the different methods for performing the initial configuration of the SG200 appliance.
Guides users through configuring the SG200 using a web browser, including connecting to a PC.
Describes how to connect the SG200 appliance to the network for initial setup.
Details the process of configuring the SG200 via a direct serial port connection.
Explains how to perform initial configuration remotely before physical installation.
Instructions on accessing the SG200 via Management Console or Command Line Interface.
Troubleshooting steps for issues with network link establishment on the SG200.
Solutions for problems related to accessing the SG200's initial configuration web page.
Steps to troubleshoot if the SG200 appliance fails to power on.
Guidance on resolving issues when unable to access the SG200's serial console.
Troubleshooting steps for issues connecting to the SG200's management console.
Explains how to interpret the System LED status and identify potential problems.
Information about security warnings during initial configuration and their meaning.
Procedure to restore the SG200 appliance to its original factory default settings.
Instructions on creating a static route from a PC to the SG200 for initial configuration.
Steps for removing the pass-through card for specific operational requirements.
Explains certificate issues when the SG200's IP address is changed.
Troubleshooting steps if the SG200 fails to restart after a reboot.
Details the environmental and electrical specifications of the SG200 appliance.
FCC Class A digital device warning regarding radio frequency interference.
EMC warning for Class A products in domestic environments.
Compliance statement for Canadian ICES-003 for Class A digital apparatus.
EMC warning for Class A products in domestic environments for Australia/New Zealand.
BSMI notification for Class A information products regarding potential RF interference.
VCCI notification for Class A information technology equipment in Japan.
CCC notification for Class A products regarding potential radio interference.
Cautionary notes regarding battery installation and replacement for safety.
States conformity of the Model 200 with relevant European standards.
To Next Page
General