Blue Lagoon UV-C Timer - Page 82

6
electrical unit or the display is replaced, the entire box must be unscrewed and the wiring must be disconnected from the device (see drawing 1).
Unscrew the screw top (N) and carefully remove the lamp holder from the lamp. Any loose parts, i.e. of the earth etc., must be carefully
retained, as they are not supplied with a new housing or electrical unit. In case of any doubt with regard to the connection, consult a
recognised tter.
8 If the housing needs replacing, the earth (J) and the electrical unit with the display (S) must rst be disconnected from the housing (U)
(see drawings 1 & 2). Unscrew the electrical unit with display (S) and the lamp holder from the housing. Be sure to carefully retain the
various loose parts of the earth, as they are not supplied with a new housing. Remove the lamp (K) and quartz glass (M) from the housing
in order to prevent breakage during transport. In case of any doubt with regard to the connection, consult a recognised tter.
9 Disconnect the ow switch from the glued socket. Unscrew the three-part couplings and remove the housing from the pipe clips.
Technical specications
• Philips TUV T5 lamp 130 Watt
• UV-C output (W) 50 Watt
• UV-C (%) after 4,500 hours 85%
• Swimming pool content (l) 150.000 l
• Max. throughput 30.000 l/h
• Max. pressure 3 bar
• Connection size Ø63 mm
• Length of the device 100 cm
UV-C system types
Article number: B210006 Blue Lagoon UV-C Timer 150,000 l / 130 Watt (230V; 50/60Hz)
Replacement lamps
Article number: E800904 Lamp type TUV 130 Watt 4P-SE Amalgam (130 Watt)
Terms of guarantee
You have made an excellent choice in selecting this product. The device has been assembled carefully and in compliance with all applicable
safety regulations. For reasons of quality, the supplier has only made use of high-quality materials, and provides a guarantee for the device
covering material and manufacturing faults for a period of 2 years from the date of purchase. The lamp and the quartz glass are not included
in this guarantee. Claims under the guarantee can only be considered if the product is returned post-paid together with a valid purchase
receipt. Repairs under the guarantee may exclusively be carried out by the supplier.
Guarantee claims that are caused by errors in the installation or operation of the device will not be considered. Defects originating from poor
maintenance are also excluded from the guarantee. The supplier will in no way whatsoever be held responsible for any damage caused by the
incorrect operation of the product. The supplier will not be liable for any consequential damage caused by the breakdown of the device.
Complaints regarding transportation damage will only be considered if the damage was established or conrmed on delivery by the carrier
or the postal authorities. A claim can only be made against the carrier or the postal authorities if this has been done.