EasyManua.ls Logo

BLUE OAK LP GAS - User Manual

Default Icon
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
LP GAS
Fire Table
Owner’s Manual

Table of Contents

Questions and Answers

  • L
    Lisa MccallJul 29, 2025
    Why won't my BLUE OAK Indoor Furnishing burner light?
    • A
      Amber WilsonJul 30, 2025
      Several factors can prevent your BLUE OAK Indoor Furnishing burner from lighting. First, the propane cylinder might be frosted over; wait for it to warm up. Second, an opening could be blocked; clear any blockages. Third, ensure the control knob is in the ON position. Fourth, too much glass bead covering the burner bowl or small pieces blocking the burner holes can be the reason; remove some glass fire rocks. Finally, the LP tank might be empty; replace it with a full one.
  • B
    brandon10Aug 8, 2025
    What to do if carbon build-up and/or thick black smoke is present in my BLUE OAK Indoor Furnishing?
    • A
      Andrew DavisAug 9, 2025
      If you notice carbon build-up or thick black smoke, it could be due to dirt or film on the reflector and burner screen; clean these components. Alternatively, the burner might be blocked; remove any blockage and thoroughly clean the burner inside and out.
  • S
    sanchezjustinAug 18, 2025
    How to fix a low burner flame on my BLUE OAK Indoor Furnishing?
    • B
      Belinda FinleyAug 18, 2025
      A low burner flame could be due to several reasons. The gas pressure might be low; turn off the cylinder valve and replace the cylinder. If the outdoor temperature is below 40°F and the tank is less than ¼ full, use a full propane cylinder. Also, check the burner and openings for any blockages.

Summary

Safety Information

General Dangers

Risks of fire, explosion, injury, or death if manual is not followed.

Carbon Monoxide Hazard

Danger of carbon monoxide production in enclosed spaces.

Assembly & Water Damage Cautions

LP Gas Tank Requirements

Gas Leak Procedure

Steps to take immediately if gas odor is detected.

Leak Checking Procedure

Detailed steps and precautions for performing leak checks before operation.

Installation & Service Risks

Outdoor Use Only

Gas Smell Response

Steps to take if gas smell is detected, including contacting authorities.

Assembly Instructions

Step 1: Attach Table Top

Step 2: Install LP Tank

Step 3: Add Fire Glass

Operating Instructions - Lighting

Prepare for Lighting

Open LP tank door and turn the LP tank gas valve on.

Ignite the Burner

Use a lit match or long-necked lighter near the burner ring.

Adjust Flame and Check

Turn gas control knob to high and check for normal flame appearance.

Operating Instructions - Extinguishing

Turn Off Gas Control

Push and turn the gas control knob to the off position.

Turn Off LP Tank Valve

Turn the LP tank valve completely off clockwise and close the door.

Secure the Fire Table

Once cooled, replace the fire table lid.

Checking for Leaks

Leak Detection Preparation

Leak Test Procedure

Maintenance

Care & Cleaning

Troubleshooting

Burner Issues

Smoke and Build-up

BLUE OAK LP GAS Specifications

General IconGeneral
BrandBLUE OAK
ModelLP GAS
CategoryIndoor Furnishing
LanguageEnglish