2. Install the desiccant bag near the Fathom-X Tether Interface. This step will have to be
combined with installing the Watertight Enclosure (4” Series) over the Electronics Tray
since the bag will be “floating” inside of the enclosure
[Pictures Coming Soon]
Mounting the Electronics Enclosure onto the Frame
To mount the Electronics Enclosure to the frame, you need the following parts and tools:
• 1 x Watertight Enclosure for ROV/AUV (4” Series) with Dome End Cap installed
• 1 x Bag with four M3x16 screws
• 1 x 2.5 mm hex driver
1. Apply silicone grease to the two radial O-rings on the O-Ring Flange (4” Series) that is
attached to the Electronics Tray then install the Watertight Enclosure (4” Series) with
installed Dome End Cap to the O-Ring Flange (4” Series).
2. Mount the Electronics Enclosure to the frame using the M3x16 screws so that the
dome is on the same side as the front center panels (the center panels without the 3
large holes). Install the M3x16 screws through the clips and into the Enclosure Cradle
(4” Series). It is easier to install these screws if the clips are not fully tightened until all
screws are through the clips and threading into the Enclosure Cradle (4” Series). This
allows to clips to rotate so you can find the threaded hole in the Enclosure Cradle (4”
Series) easily.
To Next Page
Loading...
Need help?
General
