Blue Seal G50 - User Manual

39 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

-1-

Revision 3/F3601

SERVICE MANUAL

G50 / G50-8 GAS RANGE

Table of Contents

Questions and Answers

P
Peter CummingsAug 1, 2025
Why won't the main burners light on my Blue Seal G50 Ranges?
- J
  Jose CampbellAug 1, 2025
  If the main burners on your Blue Seal Ranges won't light, several issues could be the cause. It might be due to wrong size or blocked injectors, requiring you to replace or clean them. An obstruction in the burner itself could also be the problem, so try cleaning the burner. Incorrect supply pressure or a faulty gas control could also be responsible; in these cases, check the supply pressure or replace the gas control.
M
Mrs. Deborah KingAug 8, 2025
What to do if main burner goes out when knob released on Blue Seal Ranges?
- A
  Anthony CunninghamAug 8, 2025
  If the main burner on your Blue Seal Ranges goes out when the knob is released, it could be due to a few reasons. Try holding the control knob in for a longer period, about 30 seconds, to allow the thermocouple to heat up properly and see if the pilot stays lit. If that doesn't work, the thermocouple itself might be faulty and need replacing. Alternatively, the gas magnet could be faulty, requiring replacement as well.
J
jennifer95Aug 15, 2025
Why is the main burner flame incorrect color (yellow / wavy) on my Blue Seal G50 Ranges?
- S
  Shawn HernandezAug 16, 2025
  If the main burner flame on your Blue Seal Ranges has an incorrect color (yellow or wavy), the aeration setting is likely incorrect, so you should adjust aeration.
C
Carolyn HortonAug 25, 2025
How to fix no low fire on Blue Seal G50?
- E
  Evan JonesAug 25, 2025
  If you're experiencing no low fire on your Blue Seal Ranges, it could be due to a couple of reasons. First, check the supply pressure, as an incorrect supply pressure can cause this issue. Another potential cause is an incorrect low fire adjustment, so make sure to adjust it.

Summary

Blue Seal G50 Gas Range Specifications

Installation Guide for Blue Seal Gas Range

Before Connection

Checks before connecting the appliance to gas supply.

Assembly

Instructions for assembling the appliance legs and rollers.

Gas Connection

Details on connecting the gas supply to the unit.

Location

Specifies required air space and clearance from combustible surfaces.

Commissioning

Steps to take before leaving the new installation, including checks.

Rating Plate Location

Indicates where the appliance's rating plate is located.

Blue Seal Gas Range Operation

Operation

General operating procedures for burners and oven.

Hob Open Burners

Step-by-step guide to lighting and operating hob burners.

Griddles

Procedure for lighting and operating griddle burners.

Oven

Instructions for lighting and setting the oven temperature.

Explanation of Control System

Safety System

Overview of the flame failure safety system and its components.

Thermocouple

Description of the thermocouple's function and construction.

Electromagnetic Flame Failure Gas Valve

Role of the gas valve in the safety system.

Maintenance Procedures

Cleaning

Instructions for cleaning the exterior and interior of the appliance.

Routine Procedures

Recommended semi-annual service checks to be performed.

Trouble Shooting Guide

Hob

Lists common faults and remedies for hob burners.

Griddle Burners

Lists common faults and remedies for griddle burners.

Oven

Lists common faults and remedies for oven operation.

Burners Do Not Burn Correctly

Troubleshooting incorrect burner flame appearance (yellow/wavy).

Set Temperature Not Reached

Troubleshooting for the oven not reaching the set temperature.

Oven Too Hot

Troubleshooting for the oven exceeding the set temperature.

Door Does Not Close

Troubleshooting for oven door sealing issues.

Service Procedures

Fault Diagnosis

Procedures for identifying specific burner and ignitor faults.

Access

Steps to access internal components of the appliance.

Replacement - Hob

Step-by-step instructions for replacing hob components.

Replacement - Oven

Step-by-step instructions for replacing oven components.

Adjustment; Calibration

Procedures for adjusting and calibrating appliance parts.

Spare Parts List

Parts Diagram

Main Assembly

Illustrated diagram of the main assembly of the G50C model.

Gas Piping Assembly

Illustrated diagram of the gas piping assembly for the G50C model.

Service Contacts

Blue Seal G50 Specifications

General

Brand	Blue Seal
Model	G50
Category	Ranges
Language	English