Blue Square Q360 - Water Valve Instructions; Servicing the Q360 Water Valve or replace the Cassette?

Page | 3
V14612HOM
Water Valve Instructions
The Complete Q360 VALVE
Shown on Figure 1
Figure 1
Servicing the Q360 Water Valve or replace the
Cassette?
NOTE; if while the pump is on, the turbine
spins and the valve is changing zones there
is no technical reason to open the valve.
1. Turn off the pump at the pool equipment.
2. Loosen the bolt on band clamp and
remove the band clamp and clear lid.
3. Remove the turbine and Cassette by
sliding them off of the center shaft.
4. Install the cassette by sliding it onto the
center shaft. Spin the gears and make
sure the cassette drops all the way down
and the lower gear engages with the
gear train on the housing perimeter.
5. Place the turbine on the center shaft
gear side down. Make sure the gear on
the turbine engages the upper gear on
the cassette. Spin the turbine several
times and observe the white bottom
plate is slowly turning. If it does not, the
cassette is not in the full “down” position
and the lower gear is above the gear
train on the housing perimeter.
6. Check positioning of large O-ring on the
clear lid and make sure it is free from
debris and properly seated in the O-ring
groove.
7. Align the center shaft on the guide pin
hole in the clear led and gently push the
lid down. The lid should sit firmly and seat
on the top of the valve housing with no
wobble.
8. Replace the band clamp and tighten the
bolt firmly. Do not over tighten.