III. Installation
1. Fill the hose sections with water to eliminate air pockets
2. Adjust regulator valve if needed.
Twist and push the female ends onto the male ends
after dipping the ends into the pool to wet them. See
Figure 3. Continue until you've connected all the
sections you need. Then connect the HOSE to the
cleaner. One of the hose sections has 2 female ends.
Your fully assembled cleaner should look like this.
IV. Tips
• Filters with 1500 gallons or less, close regulator valve 100%
• Filters with 2500 gallons, open valve accordingly so that Auto Vac does not run too fast.
• The proper speed for cleaner is about 3 feet per minute.
To Next Page
Loading...