Bluedio Headphones
Model: Victory
Thanks for your support
Thank you very much for buying this product.
Advice and assistance
Please login to www.bluedio.com search for relative product information and technical support, please
contact us via email or phone if necessary.
Original goods verification
If you are not sure the Bluedio product is original or not, please login www.bluedio.com, enter the
verification code on back of the box’s sticker.
Security Precautions:
In order to have a proper and safety use of the headphone, please read this user manual in detail and
in good keep.
Be sure to aware the following guidelines when using your headphone.
1. Should adjust reasonable volume and time when using the headphone.
2. Please stop using the headphone if there is any danger to ensure your safety.
3. Be careful not to turn the volume so high that you can’t hear anything around you. If there is a
tinnitus or the volume is too high, please reduce the volume.
4. Please avoid using headphone to listen to music, make or receive calls to avoid distraction while
driving.
5. Put this product and its accessories somewhere out of the reach of children, to avoid
inappropriate use by children which may cause a fatal danger.
6. Should avoid water entering the headphone during grooming, which may cause damage to the
sound quality or the headphone.
7. Stop using the headphone if you feel obvious discomfort, irritation or have other adverse
reactions.
8. The headphone should not be stored or use at temperatures below -15°C (5°F) or above 55°C
(131°F) which may shorten headphone or battery life.
Charger and battery
Please check the charging cable is original or not before charging the Bluetooth headphone.
Warning: Must use original charge cable to charge for the Bluetooth headphone, otherwise it may
damage the headphone. Thus, voltage of charger most be 5V, electric current exceed 400mA
(5V/400mA).
Charging: This headphone uses a non-detachable built-in rechargeable battery. In order to prevent
damage of the headphone, please do not remove the battery.
1. Before charging, make sure the headphone has been switched off.
2. Plug USB cable into the charging port of headphone; plug the other side of USB cable into the USB
charger or other charging device. Charging will start and the red light remains bright on the
headphone.
3. It takes approximately 3 hours for charge complete, blue light remains bright or red light switch
off after charging completed.
Accessories
To Next Page
Loading...
