The Steroid 1 Signature has a wide inductive and resistance acceptance so it can be matched with any kind of audio cables.
Its chassis is made of Steel to minimize RFI and EMI interferences. Selected components have thight tolerances. The use of
a Dual-Mono power supply allows the S - 1 sound open, natural, significantly better than the already remarkable little
brother Steroid 1 .
Congratulations & Introduction 3
S - 1 Italian Prestige Integrated Amplifier
Contents of Packaging
- INTEGRATED AMPLIFIER
- REMOTE CONTROL FOR VOLUME CONTROL ONLY
- DETACHABLE AC POWER CHORD
- INSTRUCTIONS AND WARRANTY CERTIFICATE
Positioning of the S - 1 Integrated Amplifier
The S - 1 integrated amplifier has been designed for use in Hi-Fi systems in sheltered locations. It ought therefore to be protected from any
eventual variations in temperature and humidity. Avoid using in the vicinity of radiators or other strong heat sources, electrical and electronic
motors, switched on mobile phones etc.
The location in proximity of other audio components is not theoretically critical, but you should nevertheless pay attention to this. If it should
have to be moved after the installation, certain readjustments may need to be made. In any case, take care to switch OFF and detach the AC
power chord from the AC wall plug the S - 1 \integrated amplifier every time you need to move it.
The high weight of the amplifier is not suitable to be positioned on any other components of the hi-fi system.
Operating Conditions
Once it has been correctly mounted and wired with its AC power Chord, and once the unit is been wired to a line input of the amplifier with a
proper interconnect cable, your STEROID Signature integrated amplifier is ready for use. TO PREVENT HIGH QUALITY SOUND
To Next Page
Loading...