Blueprint LS Series - Page 10

9
SUPERCHARGED LS COOLANT ROUTING THROTTLE BODY WIRING ADAPTER
ICT Billet makes an LS Swap Gauge Sensor to go from the stock LS M12-1.5 to
female 3/8" NPT if you want to run your old coolant sensor.
This would be handy for our PSLS4270CTC engine that runs a carb.
COOLANT TEMPERATURE SENSOR ADAPTER
Chevrolet Performance Throttle Body Wiring Adapter
SDTRKADPTG
Adapts LS2, LS3, LS7, and L99 90mm or L92 87mm 6-pin
gold blade throttle body to 78mm 8-pin harness. For use
on 2003-06 and 2007 classic full size GM trucks, 2004
Chevrolet SSR, and 2004-05 Holden VZ LS1 vehicles.
LS COOLANT PATH FLOW
ENGINE BLOCK
CYLINDER HEAD
Steam Tube
Heater
Out
Heater
In
1-¼"
¼"
Thermostat
Water Pump
Water Pump
Outlet
Water Pump
Inlet
Pressure Bottle
(Surge Tank)
Heater Core
Radiator Cap
Non-Pressurized Cap
Overflow
Tank
Drain
Cock
Radiator Vent Port
Radiator Steam Port
Radiator Inlet
Radiator Outlet
RADIATOR
Fill Line
Air
Air
Air
Fan
1-¼"
⅝"
1-½"
1-½"
Fuel Inlet
Manifold
Vacuum Port
Heat
Exchanger
Steam Port
to Radiator
PSLS4272SCT Magnuson Blower info
Shown Right Side / Top Up