If the oil pressure sensor won’t fit up in the rear of the intake, you can
remove the plate highlighted in yellow and install ICT Billet’s 551534
oil sensor relocation adapter, or a similar one to provide oil pressure
down by the oil filter. ITC Billet also makes a similar one that has two
output ports if you need to run an oil cooler or have other sensors.
Remove
OPTIONAL
CATCH CAN
See red circle on
BPPLS01013
Without catch can, use GM# 12594779
This is not the throttle body – it’s a port into the
intake tube AFTER the filter, but BEFORE the TB
OIL
Dirty side of the
PCV system
OPTIONAL
CATCH CAN
See red circle on
BPPLS01013
Dirty side of the
PCV system
This is not the throttle body – it’s a port into the
intake tube AFTER the filter, but BEFORE the TB
OIL
PCV HOSE ROUTINGS (LS3 BASED ALUMINUM BLOCK ENGINES)
PCV HOSE ROUTINGS (6.0 BASED IRON BLOCK ENGINES)
OIL PRESSURE RELOCATION
8
To Next Page
Loading...