Blueridge BHP15 User Manual

Page 1 of 11506318-03B Issue 1850
Save these instructions for future reference
INSTALLATION INSTRUCTIONS
BHP15 SPLIT SYSTEM HEAT PUMP
(R410A REFRIGERANT)
(P) 506318-03B
*P506318-03B*
Manufactured By
Blue Summit LLC
8201 C National Turnpike
Louisville, KY 40214
This manual must be left with the homeowner for future reference.
This is a safety alert symbol and should never be ignored. When you see this symbol on labels or in
manuals, be alert to the potential for personal injury or death.
Installation or repairs made by unqualied persons can
result in hazards to you and others. Installation MUST
conform with local building codes and with the National
Electrical Code NFPA 70/ANSI C1-1993 or current
edition and Canadian Electrical Code Part 1 CSA C22.1.
WARNING
Improper installation, adjustment, alteration, service
or maintenance will void the warranty. The qualied
installer or agency must use factory-authorized kits
or accessories when added to this products. Refer to
the individual instructions included with the specic
accessory kit.
CAUTION
These instructions are intended as a general guide and
do not supersede national, state or local codes in any
way.
NOTE
These instructions and warranty are to be given to the
owner or displayed near the indoor air handler unit.
NOTE TO INSTALLING DEALER
Before installing, modifying, or servicing system, main
electrical disconnect switch must be in the OFF position.
There may be more than 1 disconnect switch. Lock out
and tag switch with a suitable warning label. Electrical
shock can cause personal injury or death.
WARNING
Table of Contents
Safety Precautions ......................................................2
Installation ...................................................................2
Electrical Connections .................................................5
Start-Up Procedure......................................................6
Operation .....................................................................7
Homeowner’s Information .........................................10

Blueridge BHP15 Specifications

General

Brand	Blueridge
Model	BHP15
Category	Heat Pump
Language	English

Summary

Installation

Install on a Solid, Level Mounting Pad

Outdoor section must be on a solid, level foundation, extending beyond unit sides.

Elevate Unit

Elevate unit for clearance above snowfall and ensure drainage.

Rooftop Installations

Mount on a level platform 6 inches above roof, isolate from structure, use adequate anchoring.

Filter Drier

Importance of filter drier for system operation and warranty, field installation required.

Leak Check

Procedure for checking refrigeration lines and indoor coil for leaks after brazing.

Evacuating and Charging Instructions

Steps for evacuating the system to 300 microns and verifying connections.

Electrical Connections

Control Wiring

Details 24 VAC control wiring requirements and proper thermostat installation.

Heat Pump Application with Electric Heat Emergency Heat

How to configure thermostat for emergency heat with electric auxiliary heat.

Start-Up Procedure

Adjusting Charge

Procedure for adjusting refrigerant charge based on line set length and diameter.

Cooling Mode

Heating Mode

Operation

Emergency Heat Function (Room Thermostat)

Defrost System

Explains the components of the defrost system: thermostat and control.

Defrost Thermostat

Defrost Control

Details the defrost control board functions, timer, and relay.

Defrost Control Timing Pins

Diagnostic LEDs

Low Pressure Switch (LO-PS)

High Pressure Switch (HI-PS)

5-Strike Lockout Feature

Explains the 5-strike lockout mechanism for pressure switch trips.

Important System Information

Regular Maintenance Requirements

Condenser Coils

Troubleshooting: Before Requesting Service

Steps to check before calling for service, including thermostat, filter, and switches.