Ø DO shut off gas while changing cutting tips so as not to accidentally cause gas related
injuries.
Ø DO ensure all tightening points, brackets, wing-nuts, and lever-bolts are tight and stable prior
to turning the machine on and/or starting the gas flame.
Ø DO use a dust/fumes extraction system for cutting all materials. The operator should also
wear a protective respiratory device in accordance with welding safety standards.
Ø DO NOT make adjustments to machine while the machine is running.
Ø DO NOT remove or modify grounding plug. Only to be used on a properly grounded circuit.
Ø DO NOT leave the flame running when not in use.
Ø DO NOT hold the work piece by hand or using body. Always mechanically clamp or secure.
Ø DO NOT allow flame too close to the machine body. This can cause machine components to
fail.
Ø DO NOT allow flame to come in contact with power cords.
Ø DO NOT operate machine outside of machine specifications.
Ø DO NOT touch moving parts or cutting flame while the machine is running as death or
dismemberment could occur.
Ø DO NOT stand under machine while running. The machine can fall and cause damage or
harm to the user.
Ø DO NOT allow children or untrained personal to operate machine.
Ø DO NOT use this machine in the rain or a wet environment. If using outdoors, make sure the
adhering surface is clean and dry.
Ø DO NOT cut into steel that may contain a live electrical wire/circuit.
To Next Page
Loading...