Quick Install Guide for p2p Bluestork Cameras (iMAC)
151
9) Enter the WEP key or WIFI password in the window « PASSWORD »
10) Click on « OK » to validate the conguration.
11) Your camera is now installed on WIFI. You can unplug the RJ-45 Ethernet
cable from your camera.
12) Unplug the power supply from the camera, wait 10 seconds, then
plug the power supply again.
13) The re-boot camera is is now functional again and the images can be viewed in
the BLUEVIEW P2P MAC.
To Next Page
Loading...