11
3) How to start
After tilting the kickstand, find a stable
position on the footrest and then hold the
handle grip comfortably.
Step3. Stance for driving
Acceleration can be performed by using
the throttle of the instrument panel while
driving, and the deceleration or stop can
be performed by holding the brakes on the
handle.
Step4. Acceleration and deceleration
When turning on the product, you can start
driving by turning on the power of the LCD
panel. When driving is finished, turn off the
LCD panel.
* The power of the instrument panel will turn off
automatically after a few minutes of inactivity.
At this time, the LED lamp is also turned
off, so
turn it off with the LED lamp button when you
turn it on again.
Step1. Turning on the instrument panel
Press to choose the right gear.
You also can set the start mode,
cruise mode, electronic brake, and
Step2. Setting proper parameters
ABS function.
00
00:00
Km/h
3
TIME
98
%
PAS
⑦
①
②
⑧
Accelerator
Before driving, be sure to check the folding part, the handle part, the part where the
main fixing part of the product
is fastened well. And check the position of the fixing slide,
the QR lever locking status and the folding part fixing status.
Throttle malfunction caution
Regardless of whether the throttle is operated or not, the motor sensor may continue to
operate, causing malfunctions such as sudden acceleration. In this case, holding the brake
lever to cancel the operation. This phenomenon may be caused by corrosion of the throttling,
immersion of the throttle, disconnection of the magnet, broken off levers, and breakage of
the spring. Do not bounce the throttle lever strongly.
Caution
Bluetran Lightning
User Manual
Brake
Side stand
280mm
Tip
Switch button collection:
One button turns on/off the
lights of the whole Thunder II.
To Next Page