EN
25
SYSTEM RESET
• In DAB, FM or AUX mode, press and hold
the Menu/ button and press Tune + to
select System Reset. Press Enter to reset
the system to its factory settings. All preset
information is deleted.
• To check the software version, press and
hold the Menu/ button and press Tune –
or Tune + until the software version is
shown (V1.1xx).
MAINTENANCE
CLEANING
• Clean and disinfect the headband, cups
and sealing rings regularly. Use a soft
cloth moistened with hot water and a
mild detergent that does not irritate the
skin.
• Make sure that moisture does not collect
in the cups.
• Always clean the product before long-term
storage.
• Allow the product to completely dry before
using.
STORAGE
• Remove the batteries if the product is not
going to be used for some time.
• The product is protected by bubble wrap
and then put into a printed gift box. After
use, put it back into to the gift box for
storage.
TROUBLESHOOTING
If the radio stops working:
• Check if the battery cord is properly
inserted into the power connector.
• Ensure that the hearing protector is dry.
• Recharge the battery.
answer.
• Keep the Tune – button pressed for
2 seconds to reject the call.
• Keep the Tune + button pressed for
2 seconds to call the last called number.
• Incoming and outgoing calls from the
Bluetooth unit are prioritised before FM/
DAB+/AUX. Music or radio will not play,
even if the Mode button is pressed, before
the call ends.
• The user can receive calls in radio and AUX
mode, even if the product is paired with a
Bluetooth unit.
FM
• Press the Mode button to switch to FM
mode. Press and hold Tune – or Tune + to
search for radio stations. Cancel the
search when a clear signal is received.
• Search for radio stations manually by
tapping Tune + or Tune –.
• Press the Menu/ button to show any RDS
information from the supplier.
• To store and listen to radio stations, follow
the instructions above for setting DAB+
radio stations.
• Tap Enter to set audio mode Mono/Auto
(only in FM mode).
BASS BOOST
• To activate bass boost, press Enter until
Bass is shown on the display. To deactivate
bass boost, press Enter again until Bass
goes o on the display.
AUX INPUT
• Press the Mode button to switch to AUX IN
mode. Conrm with Enter. Connect the
required audio device by inserting a 3.5
mm AUX connector in the AUX input. Play
music on the connected audio device.
To Previous Page
Loading...