Blueworks BLH Series - Important Safety Instructions; Cautions and Operating Safety

2 | P a g e
BLUEWORKS BLH Series
SALT CHLORINE GENERATOR
INSTRUCTIONS READ BEFORE USE
There are basic safety precautions that you need to follow to be safe.
Including,
Cautions
Please note, the total working hours for the CELL should be less than 8
hours total per day. If you are using a variable speed pump for 24 hours
a day be sure to adjust the chlorine output to 25-30%. If the pump is
only running 10 hours per day adjust the chlorine output between
60-80%.
You can use this calculation to calculate the appropriate chlorine output
for your pool, suggest at 6 hours per day.
Pump running 24(Hours a day) *25% (Chlorine Output) =6hr (cell run time per day at 25%).
Pump running 20(Hours a day) *30% (Chlorine Output) =6hr (cell run time per day at 30%).
Pump running 15(Hours a day) *40% (Chlorine Output) =6hr (cell run time per day at 40%).
Pump running 12(Hours a day) *50% (Chlorine Output) =6hr (cell run time per day at 50%).
Pump running 8(Hours a day) *75% (Chlorine Output) =6hr (cell run time per day at 75%).
Start the VS pump on a low speed and kick the speed up until the salt
system works.
If your swimming pool has natural stone as a covering or decorative
layer, please consult stone installation experts for stone maintenance
before installing BLH.
When installing and using this electrical equipment, basic safety
precautions should always be exercised, including the following: