If the computer is free for over 300 seconds, the
computer will automatically enter into Sleep Mode
and hide all data but CLK. It will turn back to the
previous mode with all the data when any signal is
inputted or any button is pressed.
Signal Interference-resistance
This cycle computer can be anti-interference from
other signals. The distance is within 60cm.
Back Light
The back light is only on when you press any
button from 6 pm to 8 am.
Installation Introduction
Install Computer Battery
Remove the battery cover from the back of the
computer by using a coin. install one CR2032
battery with the positive (+) pole facing the
battery cover and then replace the cover. If the
LCD show irregular figures, please take out the
battery and re install it.
Install Sensor Transmitter Battery
Open the battery cover of the sensor, install
CR2032 battery with the positive (+) pole facing
4
To Next Page
Loading...