DA11AU QUICK REFERENCE GUIDE
01contact support@blustream.co.uk / support@blustream.com.au
Our DA11AU has been designed to convert unbalanced or balanced 2ch analogue
audio to Dante® digital signal. The DA11AU allows any non-Dante® audio source
such as mixing consoles, amplifiers, computers and Blustream Matrix products or
distribution products to be connected as a source within a Dante® network. The
DA11AU is a plug & play device that is powered using PoE (Power Over Ethernet)
from any PoE network switch and supports AES67 RTP audio transport.
Introduction
• Analogue audio inputs support both balanced and unbalanced audio signals
• Supports 44.1, 48 & 96 KHz sample rates @ 24 Bit
• Configurable Dante® device latency (supports 1, 2 or 5ms configurable using Dante® Controller)
• Supports AES67 RTP audio transport
• Features Class 1 802.3af PoE for powering of product from any PoE switch
DA11AU
Quick Reference Guide
FEATURES:
Connections:
1 Dante® Audio Output - RJ45 socket connets to your Dante® network.
2 Audio Input - Phoenix Connector accepts balanced or unbalanced 2 channel audio input.
Front Panel
1
Rear Panel
2
To Next Page
Need help?
General
