Safety
If the power cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
The appliance should not be placed immediately
below a socket.
WARNINGS: In order to avoid overheating, do
not cover the heater.
Do not use this heater with a programmer, timer,
separate remote control system or any other device
that turns on the heater automatically because
there is a risk of fire if the device is covered or
placed incorrectly.
CAUTION: To avoid hazard due to inadvertent
resetting of the thermal cutout, this appliance must
not be powered via an external switch, such as a
timer, or connected to a circuit that is regularly
switched on and off by the electricity supplier.
This heater must not be disposed of with household
waste; it must be taken to a local centre of
recovery and recycling of electrical appliances.
The heater must be installed so that switches and
other control devices can not be touched by a person
in the bath or shower.
A means of disconnection from the power supply
having a contact opening distance of all poles must
be included in the fixed wiring in accordance with
the installation requirements.
04EN
To Next Page
Loading...
