7
Snap-in Adapter*
Inserting snap-in adapter
1. Press button, arrow 1.
Remove cover
2. Insert the snap-in adapter and press down
until it engages.
To remove the snap-in adapter:
Press button, arrow 1.
Inserting the mobile phone
1. Remove the protective plug from the mobile
phone’s antenna connector if necessary, so
that the mobile phone can be engaged in
the holder
2. Insert the mobile phone and press down
lightly until it snaps into place.
The battery is charged from ignition key posi-
tion 1 and higher. When the ignition key is
turned back to position 0, the battery continues
to be charged for some minutes.
To protect the car’s batteries, avoid using
the phone for prolonged periods when
the ignition is switched off.
To Next Page
Loading...
