BMW 318D - Page 297

Climate control for a specified
departure time
General
To ensure a pleasant interior temperature in the
vehicle at the start of the journey, it is possible to
set scheduled departure times in the system.
▷ One-off departure time: the scheduled depar‐
ture time can be set.
The system is switched on as a one-off.
▷ Departure time with day of the week: the
scheduled departure time and day of the
week can be set.
Departure time preselection is done in two
stages:
▷ Set departure times.
▷ Activate departure time.
The system is switched on around 10 minutes
before the set departure time and remains on for
up to around 5 minutes after the set departure
time.
At least 10 minutes should pass between adjust‐
ing/activating the departure time and the sched‐
uled departure time, so the climate control has
enough time to work.
For safety reasons, the system can only be
switched on once. The system will be available
again once the drive-ready state has been activa‐
ted and deactivated again.
Observe the information regarding intended use
of the vehicle, see page 10.
Setting the departure time
Via iDrive
1.
"CAR"
2. "Settings"
3. "Climate comfort"
4. "Aux. climate control/ventilation"
5. Select the required departure time.
6. Set the departure time.
7. Select the day of the week if necessary.
Using BMW display key
1. Switch on the display of the BMW Display
key.
2. "Precondit. setting"
3. Tap the symbol.
4. Select the required departure time.
5. Set the departure time.
6. Select the day of the week if necessary.
7. "OK"
Activating the departure time
Operating requirements
If a desired departure time is to control when the
system is switched on, the relevant departure
time must be activated first.
Via iDrive
1.
"CAR"
2. "Settings"
3. "Climate comfort"
4. "Aux. climate control/ventilation"
5. Activate the required departure time.
, Symbol on the automatic air condition‐
ing system signals when a departure time is ac‐
tive
Using BMW display key
1.
Switch on the display of the BMW Display
key.
2. "Precondit. setting"
3. Tap the symbol.
4. Activate the desired departure time:
Tap the symbol.
, Symbol on the automatic air condition‐
ing system signals that a departure time has
been activated.
Seite 297
Air conditioning
CONTROLS
297
Online Edition for Part no. xxx - VI/19