BMW 520D - Page 123

123n
OverviewControlsMaintenanceMinor repairsDataKeywords
Integrated universal remote control
*
Programming
1 Channel buttons
2 Indicator light
3 Receiver for programming
Comply with the safety precau-
tions on page 122.
<
1. Ignition key position 2
2. Initial start-up: press both outer
buttons 1 until indicator light 2
flashes, then release them. This will
deactivate the three channel buttons
390de640
3. Hold the original handheld trans-
mitter against receiver 3 (not more
than 5 cm/2 in away)
4. Press the command button on the
original transmitter (arrow 2) and the
desired channel button on the inte-
grated universal remote control
(arrow 1) at the same time. Release
both buttons when the indicator light
flashes rapidly
5. To program additional original trans-
mitters, repeat steps 3 and 4.
The channel buttons you have chosen
are then programmed w ith the signal
from the corresponding original hand-
held transmitters.
380de712
Programming an alternating-code
transmitter
Comply with the safety precau-
tions on page 122.
<
When programming the integrated
universal remote control, consult the
operating instructions for the device in
question. To use the integrated
universal remote control with an alter-
nating-code system, the following addi-
tional programming instructions must
be complied with:
If a second person is available,
this will simplify programming of
the integrated universal remote
control.
<
ba.book Page 123 Tuesday, December 17, 2002 4:26 PM