124n
Integrated universal remote control
*
Glove box
1. First program the integrated
universal remote control as
described above in "Programming"
2. Keep the programming button at the
receiver pressed in for about two
seconds, until the programming light
on the unit's own device comes on
3. Press the chosen channel button on
the integrated universal remote
control three times.
If you have any queries in this
connection, please contact BMW
Service.
<
Deactivating the channel buttons
Comply with the safety precau-
tions on page 122.
<
Individual channel buttons cannot be
deactivated. Only all three channel
buttons together can be deactivated
together as follows:
>
Press the two outer channel buttons
of the integrated universal remote
control until the indicator light
flashes, then release them.
All channel buttons are then erased.
To open
Pull the handle. The light in the glove
box comes on.
To close
Swing the lid up.
After using the glove box, close its
lid without delay, so that it cannot
cause injury in the event of an acci-
dent.
<
To Next Page
Loading...
