BMW 520D - Page 83

83n
OverviewControlsMaintenanceMinor repairsDataKeywords
Check Control
>
"TRANS FAILSAFE PROG"
*
Have the car checked by the nearest
BMW Service; see page 72
>
"CHECK BRAKE LININGS"
Have the brake pads checked by
BMW Service; see page 144
>
"CHECK COOLANT LEVEL"
Coolant level is too low and should
be topped up at the earliest opportu-
nity; see page 152
>
"ENGINE FAILSAFE PROG"
*
Fault in the engine electronics. The
electronics will allow you to continue
your journey at reduced engine
output and engine speed.
Please arrange for the problem to be
examined by BMW Service.
>
"Outside temperature 5.0
6
"
This is an example of the display. The
actual value is shown at an outside
temperature of +3
6
or below; see
also page 77.
Messages displayed at the end
of a journey
All malfunctions which have been indi-
cated during a journey are displayed
again in succession when the ignition
key is turned back to position 0.
The following information is also
provided if appropriate:
>
"LIGHTS ON"
Warning at end of journey, when
driver's door is opened
>
"CHECK ENGINE OIL LEV"
Add engine oil at the earliest oppor-
tunity (when refuelling); see
page 150.
After the ignition key has been removed
and the display has gone out, you can
call up CHECK CONTROL displays for
up to approx. three minutes by pressing
the CHECK button. If there are several
displays, the CHECK button m ust be
pressed more than once.
Check Control test
Press the CHECK button 3 in ignition
key position 2:
The display should show CHECK
CONTROL OK.
There are no malfunctions in the
systems monitored.
Computer
For a description of the on-board
computer, see pages 84 and 89 and the
"Operating Instructions for On-Board
Computer".
You can also have Check Control
messages and computer informa-
tion displayed in another language.
<
ba.book Page 83 Tuesday, December 17, 2002 4:26 PM