24 Radio, sliding roofwith elevating rearsection
A car radio can be installed in your BMW
as an option. For operating instructions,
please consult the manual supplied for
the radio model concerned together with
the remaining car documents.
The steel-panel s]iding roof with elevat-
ing rear section installed in your BMW
can either be slid back normally, or rai§-
ed at the back to provide more intensive
ventilation of the car's interior.
To open: Unfold the hand crank. Turn
clockwise until initial pressure is over-
come. The roof can be opened to any
intermediate position and is held safely
there.
To close: Turn the hand crank anticlock-
wise to move the sliding roof panel for-
wards. It is fully closed when definite
pressure has been overcome at the hand
crank.
Raising at the rear (roof panel closed):
Unfold the hand crank and turn anti-
clockwise until initial pressure is over-
come. The roof will then begin to open at
the rear.
Lowering: Turn the crank back clock-
wise. The roof is closed when distinct
pressure has been overcome at the hand
crank.
Note: After each movement, the hand
crank should be folded back into its
re®SS.
lf the sliding roof is electrically operated,
press the rear of the rocker switch for
lowering and opening, and the front of
the switch for raising and closing.
On the electric sliding roof the sliding
and rear-end raising functions are sepa-
rate, with an electrical changeover
switch. When the roof is slid closed, the
drive motor is automatically switched off.
To raise the rear of the roof immediately
after sliding shut, release the switch, then
press it a second time. Observe a similar
routine when the roof is slid open after
lowering.
lf the power sliding roof mechanism
should fail, the roof can still be closed
manually. See "MINOR DEFECTS".
To Next Page
Loading...
