To make different adjustment to
the damping:
Repeatedly press button 1 until
the setting you want to use
appears on the display.
You can adjust the damping
characteristic while the mo-
torcycle is on the move.
The setting shown on the
display is automatically
accepted as the damping
characteristic if you allow a
certain length of time to pass
without pressing button 1.
The ESA indicator disappears
from the display as soon as
adjustment completes.
Tyres
Checking tyre pressure
Incorrect tyre pressures im-
pair the motorcycle's hand-
ling characteristics and increase
the rate of tyre wear.
Always check that the tyre pres-
sures are correct.
At high road speeds, tyre
valves installed perpendicu-
lar to the wheel rim have a tend-
ency to open.
Fit valve caps with rubber seals
and screw them on firmly to pre-
vent sudden deflation.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Check tyre pressures against
the data below.
Tyre pressure, front
2.2 bar (one-up, tyre cold)
2.2 bar (two-up and/or with
luggage, tyre cold)
Tyre pressure, rear
2.5 bar (one-up, tyre cold)
Tyre pressure, rear
2.9 bar (two-up and/or with
luggage, tyre cold)
If tyre pressure is too low:
Correct tyre pressure.
Headlight
Adjusting headlight for
driving on left/driving on
right
This motorcycle has a
symmetric-beam low-beam
headlight. If the motorcycle
is ridden in a country where
the opposite rule of the road
applies, its symmetric low-
beam headlight means that
no measures are necessary to
prevent the headlight beam from
dazzling oncoming traffic.
4
50
z
Operation
To Next Page
Loading...
