Via iDrive:
1. "My Vehicle"
2. "Plan charging/climate control"
3. "Charge for departure time"
4. "Set low cost time slot"
5. Set rate begin.
6. Set rate end.
The Digital Charging Service enables the time
window to be set automatically for certain loca‐
tions. Further information about the Digital
Charging Service is available on the Internet:
https://charging.bmwgroup.com
The vehicle can also start the charging process
before the selected time window begins or end it
after the selected time window finishes. The
starting point of the charging process is adjusted
so the vehicle can be fully charged and, if appli‐
cable, its climate controlled right up to the depar‐
ture time.
If drive-ready state is switched off, changes can
be made via iDrive.
The set time window can be ignored for the next
charging process: "Charge immediately once"
Setting the charge current for charging
via a Level 1 charging cable
Depending on the electrical mains, the vehicle
must be charged with a different charging cur‐
rent strength, refer to page 210.
Via iDrive:
1.
"My Vehicle"
2. "Plan charging/climate control"
3. "Settings charging current"
Settings are stored. When you change charging
locations you also might need to change the set‐
ting for charging.
Set the charge current strength at other house‐
hold sockets to the lowest level.
Setting the charge current for charging
via a Level 2 charging cable
Depending on the electrical mains, the vehicle
must be charged with a different charging cur‐
rent strength, refer to page 211.
When charging with a Level 2 charging cable, the
charging process can be completed faster at a
Level 2 charging station.
Via iDrive:
1. "My Vehicle"
2. "Plan charging/climate control"
3. "Level 2 (208-240V)"
Settings are stored. When you change charging
locations you also might need to change the set‐
ting for charging.
Automatically unlocking the charging
cable after the charging process
To allow other charging station customers to use
the charging function, the charging cable can be
unlocked automatically after the charging proc‐
ess is complete.
Via iDrive:
1.
"My Vehicle"
2. "Plan charging/climate control"
3. "Settings charging current"
4. "Unlock charging cable"
Stopping the charging process
The charging process can be stopped at any
time by removing the charging cable and contin‐
ued at a later time by connecting the charging
cable. This enables, for instance the use of other
loads on the power connection or prevents si‐
multaneous high power from multiple loads.
Removing the charging cable, refer to page 213.
Continuing the charging process
If the charging process is interrupted, for in‐
stance through a temporary power failure, the
Seite 217
Charging the vehicle
MOBILITY
217
Online Edition for Part no. 01402989267 - II/18
To Next Page
