In some situations, the idle state is not set au-
tomatically, for instance during a phone call or
when the low beams are switched on.
Establishing idle state when
opening the front doors
After a trip, the sleep mode can be established
by opening the front doors. For this purpose,
all passengers must exit the vehicle.
1. Apps menu
2. "Vehicle"
3. "Doors and windows"
4. "Lock/unlock"
5. "Turn off after opening door"
Establishing the sleep mode
manually
To establish idle state in the vehicle after com-
pletion of trip:
Press and hold the thumbwheel
in the center console until the
OFF indicator in the instrument
cluster goes out.
Standby state
Principle
When standby state is switched on, most func-
tions can be used while the vehicle is station-
ary. Desired settings can be adjusted.
General information
The vehicle is in the standby state after the
front doors are opened from the outside.
To preserve the vehicle battery, use standby
and the activated power consumers only as
long as absolutely necessary.
Manually setting to standby
General information
Standby can be switched back on after the ve-
hicle is automatically set to idle state.
Via thumbwheel
Press thumbwheel in the center
console. The control display and
the instrument cluster illuminate.
Via start/stop button
Press the Start/Stop button. The
control display and the instru-
ment cluster illuminate.
Display in the instrument cluster
OFF is displayed in the instru-
ment cluster. The drivetrain is
switched off and standby state
switched on.
Drive-ready state
General information
Drive-ready state is turned on or
off with the Start/Stop button.
Activated drive-ready state is the equivalent of
a running engine in conventional vehicles.
Deactivated drive-ready state is equivalent to
switching the engine off.
Seite 40
CONTROLS
Operating condition of the vehicle
40
Online Edition for Part no. 01405A88D67 - VI/23
To Next Page
Loading...
