7. Pull on the cover cap until the door opens.
8. Open the driver's door.
9. Press the central locking button to unlock
the other doors.
With the vehicle de-energized: pull the lever
in the other doors from the inside.
Locking the vehicle manually
General information
To avoid locking the vehicle key in the vehicle,
do not place the vehicle key in the vehicle.
Locking the vehicle
1.
Lock the doors to be locked with the
integrated key using the side door lock on
the front of the doors.
2. Close the locked doors.
Alarm system
If the vehicle is unlocked with the integrated
key via the door lock, the activated alarm sys-
tem will be triggered when the door is opened.
In this case, use the vehicle key emergency
detection to switch off the alarm.
If the vehicle is locked with the integrated key
via the door lock, the alarm system will not be
activated.
Emergency detection of the vehicle
key
It is not possible to switch on the drive-ready
state if the vehicle key has not been detected.
Proceed as follows in this case:
1.
Hold the rear of the vehicle key against the
mark on the steering column. Pay attention
to the display in the instrument cluster.
2.
▷ If the vehicle key is detected:
Turn on drive-ready state within 10 sec-
onds.
▷ If the vehicle key is not detected:
Slightly change the position of the vehi-
cle key and repeat the procedure.
Malfunction
A Check Control message is displayed where
applicable.
Vehicle key detection by the vehicle may mal-
function under the following circumstances:
▷
The battery of the vehicle key is discharged.
▷ Fault of the radio link from transmission
towers or other equipment with high trans-
mitting power.
▷ Shielding of the vehicle key due to metal
objects.
Do not transport the vehicle key together
with metal objects.
Seite 76
CONTROLS
Opening and closing
76
Online Edition for Part no. 01405A88D67 - VI/23
To Next Page
Loading...
