DIGITAL KEY.
KEYREADER PLUS MOBIL: VIN READING FROM KEY-CARD.
Figure 1: Configuration side for the KeyReader Plus with new button below
1. This additional function can only be used via
t
he configuration interface (see figure 1) w
ith
SW
version v.31
2. To do this, the K
eyReader Plus must be
c
onnected to a Windows computer via USB
and the KeyReader Plus USB driver must be
installed.
3. Then p
lease insert the following IP-Adress
(http://192.168.17.17) in a released Internet
Browser for ISPI Next.
4. A new button "NFC Key
Card Reading Mode"
i
s available at the bottom of the configuration
page. This puts the device in the new operatin
g
m
ode.
5. In this operating mode, normal key reading and
th
e transmission of key data is turned of
f.
6. The operating mode can be seen on the device
by the fact that the middle LED flashes white.
To Next Page
Loading...
