EasyManua.ls Logo

BMW m340i 2021 - Page 281

BMW m340i 2021
396 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
be available again as soon as the drive-ready
state is activated and deactivated again.
Via iDrive
1. "CAR"
2. "Settings"
3. "Climate control"
4. "Preconditioning/ventilation"
5. "Start now"
Via vehicle key
The system can be switched on and off using
the vehicle key.
Press the button on the vehicle key three
times within 1 second.
After operating the vehicle key, it will take ap‐
proximately 3 seconds until the engine is
switched on.
To switch off the system, press the button again
three times.
Climatization for the requested
departure time
General information
Scheduled departure times can be set up in the
system to ensure a comfortable interior tempera‐
ture in the vehicle at the time of departure.
One-time departure time: the time of the
scheduled departure can be set.
The system is switched on once.
Departure time with weekday: time and day
of the week of the scheduled departure can
be set.
The departure time is preselected in two steps:
Set departure times.
Activate departure times.
The climate control function will start approxi‐
mately 10 minutes before the set departure time
and continue for approximately 5 more minutes
after the departure time.
A minimum of 10 minutes should pass between
setting/activating the departure time and the
planned departure time to allow a sufficient pe‐
riod of time for the climate control.
For reasons of safety, the system can only be
switched on once. The system will be available
again as soon as the drive-ready state is acti‐
vated and deactivated again.
Observe the information about the intended use
of the vehicle.
Additional information:
For Your Own Safety, refer to page 8.
Setting the departure time
Via iDrive
1.
"CAR"
2. "Settings"
3. "Climate control"
4. "Preconditioning/ventilation"
5. Select the desired departure time.
6. Set the departure time.
7. Select day of the week, if needed.
Activating the departure time
Functional requirement
If a requested departure time is to influence the
switching on of the system, the respective de‐
parture time must be activated first.
Via iDrive
1.
"CAR"
2. "Settings"
3. "Climate control"
4. "Preconditioning/ventilation"
5. Activate the desired departure time.
, The symbol on the automatic climate
control signals an activated departure time
Seite 281
Climate control
CONTROLS
281
Online Edition for Part no. 01405A111C1 - VI/20

Table of Contents

Related product manuals