Fig. 126: Pressing Roller Bearing Into Dual-Mass Flywheel
Courtesy of BMW OF NORTH AMERICA, INC.
Using hydraulic press (1), press roller bearing into dual-mass flywheel as far as it will go on clutch side.
Observe press-in instruction:
Roller bearing must not be driven in.
Roller bearing mounting force/travel monitored:
Min. 2000N 1 mm before end of pressing in.
Max. 15000N during entire press-in procedure.
VIBRATION DAMPER
11 23 010 REMOVING AND INSTALLING OR REPLACING VIBRATION DAMPER (M52TU / M54 /
M56)
Special tools required:
IMPORTANT: Risk of damage:
2006 BMW X5 30i
2004-2006 ENGINE Engine Mechanical - Repair Instructions - X3 & X5 (M54)
sábado, 2 de octubre de 2021 11:25:52 p. m. Page 131 © 2011 Mitchell Repair Information Company, LLC.
To Next Page
