11 7 020
(for work step number 13 00 002), read out fault memory, clear if necessary.
Unclip oxygen control sensor cable from retainer.
Disconnect plug connection for oxygen control sensor. Release oxygen control sensor with special tool 11 7
020.
Fig. 397: Removing Oxygen Control Sensor
NOTE: The plug connection must be disconnected before the oxygen control sensor is
removed.
If the plug connection separation point is below the cover for the fuel injectors:
If necessary, remove lower section of microfilter housing. Remove cover from
fuel injectors.
2006 BMW X5 30i
2004-2006 ENGINE Engine Mechanical - Repair Instructions - X3 & X5 (M54)
sábado, 2 de octubre de 2021 11:25:57 p. m. Page 408 © 2011 Mitchell Repair Information Company, LLC.
To Next Page
Loading...
