Getting Started
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Contact Information
If you encounter any difficulty while using your BMW Navigator
V, or if you have any questions, contact your BMW Motorrad
dealer.
Installing the Battery
1
Locate the screwdriver
À
that came in the product box.
2
Locate the lithium-ion battery in the product box.
3
Loosen the screws and remove the battery compartment
cover.
4
If necessary, insert a microSD™ card
Á
into the device.
5
Insert the battery with its cable on top.
6
Insert the battery connector
Â
into the battery port
Ã
.
7
Insert the battery cover, top side first
Ä
.
8
Close the battery cover
Å
and tighten the screws.
NOTE: Do not over-tighten the screws.
Turning On the Device
NOTE: The device turns on automatically if it is in the optional
motorcycle or automotive mount and external power is
connected and turned on.
Press the power key.
Turning Off the Device
1
Hold the power key until a prompt appears on the screen.
The prompt appears after five seconds. If you release the
power key before the prompt appears, the device enters
sleep mode.
2
Select Off.
Resetting the Device
You can reset your device if it stops functioning.
Hold the power key for 10 seconds.
Removing the Battery
You can remove the battery if you do not plan on using the
device for an extended period of time.
1
Loosen the screws and remove the battery compartment
cover.
2
Press and hold the release tab on the battery connectory
while gently pulling the connector away from the device.
Installing Your Device in the Motorcycle
Mount
CAUTION
Before driving, ensure the top of the latch is flat and even with
the top of the device and the mount.
NOTE: The motorcycle mount is not included in all kits.
1
Fit the bottom of your device into the cradle.
Getting Started 1
To Next Page
Loading...
Need help?
General
