BMW R 1200GS Rallye 2017 User Manual

Deactivate the RDC for
off-roading
with riding modes Pro
OE
Requirement
The motorcycle should be driven
with reduced tyre pressure when
off road.
Requirement
Either the ENDURO or ENDURO
PRO riding mode has been set
in order to be able to switch the
RPA off.
NOTICE
If Connectivity optional equip-
ment is installed, the menu guid-
ance can be found in the vehicle
operating instructions.
Switch on the ignition.
Repeatedly press button 1
briefly until the top display
line 2 shows SETUP ENTER.
Press and hold button 1 to
start the SETUP menu.
Press button 1 briefly to go to
the next menu item RDC.
In the top display line 2, RDC
is displayed.
The bottom display line 3
shows the preset value.
Press button 4 briefly in order
to change the set value.
The following settings are pos-
sible RDC Enduro:
ON: the RDC warning symbol in
the display does not show. Only
a tyre pressure that is outside the
permitted tolerance is displayed.
5
23
z Off-road use

BMW R 1200GS Rallye 2017 Specifications

General

Displacement	1170 cc
Bore x Stroke	101 mm x 73 mm
Max Torque	125 Nm at 6, 500 rpm
Transmission	6-speed
Curb Weight	244 kg
Final Drive	Shaft drive
Front Tire	120/70 R19
Rear Tire	170/60 R17
Wheelbase	1, 507 mm
Compression Ratio	12.5:1
Fuel System	Electronic fuel injection
Max Power	125 hp at 7, 750 rpm
Fuel Capacity	20 liters
Front Suspension	Telelever, central spring strut
Rear Suspension	BMW Motorrad Paralever
Front Brakes	Dual disc, floating brake discs, diameter 305 mm, 4-piston radial calipers
Rear Brakes	Single 276 mm disc, 2-piston caliper
ABS	BMW Motorrad ABS
Frame	Two-section frame, front- and bolted on rear frame
Length	2, 210 mm
Height	1, 450 mm
Clutch	Wet clutch, hydraulically operated
Engine Type	Air/liquid-cooled four stroke flat twin engine, double overhead camshaft, one balance shaft