To Next Page

To Previous Page

Open case ( 140).

First turn the key in the top-

case lock 45° past the LOCK

position, then turn it to the dot

position and press in the lock

barrel.

The release lever pops open.

Logon of remote controls

If a remote control has been mis-

laid and a replacement acquired

or if you are going to use an ad-

ditional remote control, you must

invariably log on all the remote

controls in the set.

Enable logon of the remote

controls as follows:

Switch on ignition.

Press button 2 on the remote

control three times.

One acoustic signal sounds.

Within ten seconds, switch off

the ignition.

You can now proceed to log on

all the remote controls.

Step through the following pro-

cedure with each remote con-

trol in turn:

Press and hold down buttons 1

and 2 until LED 3 stops flash-

ing.

LED 3 flashes for about ten

seconds.

Release buttons 1 and 2.

LED 3 lights up.

Press button 1 or button 2.

One audible signal sounds,

LED 3 goes out.

To complete logon:

Switch off ignition.

Three acoustic signals sound.

Logon is also ended when

four remote controls have been

logged on.

Operation

Questions and Answers:

Need help?

Do you have a question about the BMW R 1200RT and is the answer not in the manual?

BMW R 1200RT Specifications

General

Displacement	1170 cc
ABS	Standard
Engine Type	Air/liquid-cooled, four-stroke, flat-twin
Power	125 hp (92 kW) at 7, 750 rpm
Torque	125 Nm at 6, 500 rpm
Transmission	6-speed
Fuel Capacity	25 liters
Seat Height	805 mm (adjustable to 825 mm)
Weight	274 kg (with full fuel tank)
Front Suspension	Telelever
Rear Suspension	BMW Paralever
Front Brake	Dual disc, 320 mm
Rear Brake	Single disc, 276 mm
Wheelbase	1, 485 mm