To Next PageTo Next Page
Need help?Do you have a question about the BMW X5 30i 2004 and is the answer not in the manual?
General| Brand | BMW |
|---|---|
| Model | X5 30i 2004 |
| Category | Automobile |
| Language | English |
Details engine oil service, including recycling and disposal procedures.
Procedures for removing and installing the full-flow oil filter.
Removing the intake air housing and air-mass flow sensor.
Procedures for removing, installing, or replacing the oil dipstick.
Lists necessary preliminary tasks for oil dipstick service.
Procedures for removing and installing the water pump.
Removing the alternator drive belt, referencing specific instructions.
Procedures for removing, installing, or replacing the coolant thermostat.
Removing the fan clutch, impeller, and cowl.
Procedures for removing and installing the intake air manifold.
Caution to properly mark and connect oxygen sensor plugs to avoid mix-ups.
Procedures for removing and installing exhaust manifolds with catalytic converters.
Lists necessary preliminary tasks before exhaust manifold work.
Procedures for replacing oxygen control sensors.
Lists special tools required for oxygen sensor replacement.
Lists special tools required for oxygen control sensor replacement for cylinders 1-3.
Preliminary task: reading out DME fault memory.
Lists special tools required for replacing both oxygen monitor sensors.
Preliminary task: reading out DME fault memory.
An illustration identifying components of the PCV/oil separator system.
