BMW X5 - Page 295

Press the upper or lower button side to
set the desired temperature.
Via iDrive:
1. "CAR"
2. "Settings"
3. "Climate control"
4. "Heating/ventilation"
5. "Second row of seats"
6. "Temp. left:" or "Temp. right:"
7. Set the desired temperature.
The selected temperature is shown on the cli‐
mate control display.
Do not rapidly switch between different tempera‐
ture settings. Otherwise, the automatic climate
control will not have sufficient time to adjust the
set temperature.
Maximum cooling
Principle
The system is set to the lowest temperature, op‐
timum air flow and recirculated-air mode with the
drive-ready state switched on.
Functional requirement
The function is available at an outside tempera‐
ture above approx. 32 ℉/0 ℃ and with the drive-
ready state switched on.
Switching maximum cooling on/off
Press the button.
The LED in the button is illuminated
when maximum cooling is switched on.
Air flows out of the air vents to the upper body
region. The air vents need to be open for this.
AUTO program
Principle
The air flow, air distribution and the temperature
are controlled automatically.
Switching the AUTO program on/off
Using the button:
Press the button.
The LED of the button is illuminated
with the AUTO program switched on.
Via iDrive:
1.
"CAR"
2. "Settings"
3. "Climate control"
4. "Heating/ventilation"
5. "Second row of seats"
6. "Automatic"
Depending on the selected settings and outside
influences, the air is directed to the upper body
and into the floor area.
Controlling the intensity of the air
flow
With the AUTO program activated, the automatic
intensity control can be changed:
Using the button:
Pressing the lower or upper side of the
button repeatedly: decrease or increase
intensity.
Via iDrive:
1.
"CAR"
2. "Settings"
3. "Climate control"
4. "Heating/ventilation"
5. "Second row of seats"
6. "Level"
7. Set the desired intensity.
Seite 295
Climate control
CONTROLS
295
Online Edition for Part no. 01405A37D22 - VI/21