When using the automatic climate control, con‐
densation water develops and collects under‐
neath the vehicle.
Maximum cooling
Principle
The system is set to the lowest temperature, op‐
timum air flow and recirculated-air mode with the
drive-ready state switched on.
Functional requirement
The function is available with outside tempera‐
tures above approx. 32 ℉/0 ℃ and with the
drive-ready state switched on.
Switching maximum cooling on/off
Press the button.
The LED is illuminated when maximum
cooling is switched on.
Air flows out of the air vents to the upper body
region. The air vents need to be open for this.
AUTO program
Principle
Air flow, air distribution and temperature are con‐
trolled automatically.
Switching the AUTO program on/off
Press the button.
The LED of the button is illuminated
with the AUTO program switched on.
Via iDrive:
1.
"CAR"
2. "Settings"
3. "Climate control"
4. "Heating/ventilation"
5. "Third row of seats"
6. "Automatic"
Depending on the selected temperature, the
AUTO intensity, and outside influences, the air is
directed to the upper body and into the floor
area.
Controlling the intensity of the air
flow
With the AUTO program activated, the automatic
intensity control can be changed:
Press the lower or upper side of the
button: decrease or increase intensity.
Via iDrive:
1.
"CAR"
2. "Settings"
3. "Climate control"
4. "Heating/ventilation"
5. "Third row of seats"
6. "Level"
7. Set the desired intensity.
The air flow and air distribution are controlled au‐
tomatically depending on the selected intensity.
The selected intensity is shown on the climate
control display.
Air flow, manual
Principle
The air flow for climate control can be adjusted
manually.
General information
To adjust the air flow manually switch off AUTO
program first.
Adjusting the air flow manually
Press the lower or upper side of the
button: decrease or increase air flow.
The selected air flow is shown on the climate
control display.
Seite 303
Climate control
CONTROLS
303
Online Edition for Part no. 01405A385B6 - VI/21
To Next Page
Loading...
