BMW XM - Page 127

Via iDrive
It is possible to configure the required Drive-
Logic program for buttons M1 or M2.
1. Press the button.
2. "M1 CONFIGURATION" or "M2
CONFIGURATION"
3. "Transmiss."
4. Selecting the desired DriveLogic program
▷ "D1" to "D3": Drive mode.
▷ "S1" to "S3": sequential mode.
The setting is immediately applied with ac-
tive M1 or M2 configuration.
To activate the desired configuration with the
selected settings, press the corresponding but-
ton on the steering wheel:
▷
▷
Additional information:
M Setup menu, refer to page 209.
Display in the instrument cluster
The DriveLogic program se-
lected corresponds to the num-
ber of illuminated fields.
Electronic unlocking of the
transmission lock
General information
Unlock the transmission lock electroni-
cally, e.g., to maneuver the vehicle out of a
hazardous area in the event of a malfunction.
Unlocking is possible if there is a sufficient 12-
volt electrical system voltage.
Before unlocking the transmission lock, set the
parking brake to prevent the vehicle from roll-
ing away.
Engaging selector lever position N
1. Quickly press the Start/Stop button three
times without stepping on the brake.
2. Depress the brake pedal.
3. Press the selector lever to position N.
An appropriate Check Control message is
displayed.
Position N is indicated on the selector lever.
4. Maneuver the vehicle from the hazardous
area and secure it against rolling away.
Additional information:
Tow-starting/towing, refer to page 383.
Launch Control
Principle
Launch Control enables optimum acceleration
on roads with good traction under dry sur-
rounding conditions.
General information
The use of Launch Control causes premature
component wear since this function represents
a very heavy load for the vehicle.
Do not use Launch Control during the break-in.
Do not steer the steering wheel when driving
off with Launch Control.
Additional information:
Break-in, refer to page 306.
Functional requirements
Launch Control is available when the engine
is at operating temperature. The engine is at
operating temperature after an uninterrupted
trip of at least 6 miles/10 km.
Seite 127
Driving
CONTROLS
127
Online Edition for Part no. 01405A8A608 - VI/23