▷ Setting values
2 Button for:
▷ Confirming selected display or set val‐
ues
▷ Calling up computer information 63
3 With the lights switched on: dimming the in‐
strument lighting 78
4 Calling up Check Control 71
5 Checking the engine oil level 198
6 Setting the time 66
7 Setting the date 67
8 Viewing service requirement display 69
Exiting displays
The outside temperature reading and the time
reappear when you press button 2 or if you make
no entries within approx. 15 seconds. If required,
complete the current setting first.
Units of measure
You can change the units for fuel consumption,
route/distance, temperature and pressure.
1. "Settings"
2. "Language/Units"
3. Select the desired menu item.
4. Select the desired unit.
The settings are stored for the remote control
currently in use.
Clock
Setting the time
In the instrument cluster
To set the 12h/24h format, refer to Setting the
time format below.
1.
Press button 1 in the turn indicator lever up
or down repeatedly until the appropriate
symbol appears in the display, accompanied
by the time and the word "SET".
2. Press button 2.
3. Use button 1 to set the hours.
4. Press button 2 to confirm the entry.
5. Use button 1 to set the minutes.
6. Press button 2 to confirm the entry.
7. Press button 2.
The system accepts the new time.
Via the iDrive
1.
Press the button.
The main menu is displayed.
Seite 66
66
Online Edition for Part no. 01 41 2 604 231 - 03 10 500
Displays
To Next Page
Loading...
Need help?
General
