BMW Z4 - Page 184

Instrument cluster will display selected distance,
refer to page 184.
Increase the distance
Press the button repeatedly until the
desired distance is set.
Instrument cluster will display selected distance,
refer to page 184.
Continuing cruise control
An interrupted cruise control can be continued
by calling up the stored speed.
Make sure that the difference between current
speed and stored speed is not too large before
calling up the stored speed. Otherwise, uninten‐
tional braking or accelerating may occur.
Press the following button on the steering wheel
with the system interrupted:
Button on the steering wheel.
Cruise control is continued with the stored val‐
ues.
In the following cases, the stored speed value is
deleted and cannot be called up again:
▷ When the system is switched off.
▷ When drive-ready state is switched off.
Changing between cruise control
with/without distance control
Safety information
Warning
The system does not react to traffic driving
ahead of you, but instead maintains the stored
speed. There may be a risk of accident or risk
of damage to property. Adjust the desired
speed to the traffic conditions and brake as
needed.
Switch mode of the cruise control
Switching cruise control without distance control
off and on:
▷
Press and hold this button.
▷
Press and hold this button.
Switching on distance control:
▷
Press the button.
▷
Press the button.
After switching, a Check Control message is dis‐
played.
Displays in the instrument
cluster
Display in the speedometer
▷ Green marking: system is ac‐
tive, the marking indicates the
desired speed.
▷ Grey marking: system is inter‐
rupted, the marking indicates
the stored speed.
▷ No marking: system is switched off.
Distance to vehicle ahead of you
Selected distance to the vehicle ahead of you is
shown.
Symbol Description
Distance 1
Distance 2
Seite 184
CONTROLS
Driver assistance systems
184
Online Edition for Part no. 01402779113 - II/19