When using the automatic climate control, con‐
densation water develops and collects under‐
neath the vehicle.
Maximum cooling
Concept
The system is set to the lowest temperature, op‐
timum air flow and recirculated-air mode with the
drive-ready state switched on.
General information
The function is available with external tempera‐
tures above approx. 32 ℉/0 ℃ and with the
drive-ready state switched on.
Switching on/off
Press the button.
The LED is illuminated with the system
switched on.
Air flows out of the vents to the upper body re‐
gion. The vents need to be open for this.
The air flow can be adjusted with the program
active.
AUTO program
Concept
The AUTO program cools, ventilates or heats
the car's interior automatically.
The air distribution and temperature are control‐
led automatically depending on the temperature
in the car's interior and the desired temperature
setting including the selected intensity of the air
flow.
Switching on/off
Press the button.
The LED is illuminated with the AUTO
program switched on.
Via iDrive:
1. "CAR"
2. "Settings"
3. "Climate control"
4. "Heating/ventilation"
5. "Driver"
6. "Automatic"
Depending on the selected temperature, the in‐
tensity of the AUTO program, and outside influ‐
ences, the air is directed to the windshield, side
windows, upper body, and into the floor area.
The air conditioning, refer to page 211, is
switched on automatically with the AUTO pro‐
gram.
Point the side vents toward the side windows.
At the same time, a condensation sensor con‐
trols the program so as to prevent window con‐
densation as much as possible.
The AUTO program is switched off automati‐
cally, when manual air distribution is set.
Intensity
With the AUTO program switched on, the inten‐
sity can be adjusted. This changes the automatic
control for the air flow and air distribution.
Press the lower or upper side of the
button: decrease or increase intensity.
Via iDrive:
1.
"CAR"
2. "Settings"
3. "Climate control"
4. "Heating/ventilation"
5. "Driver"
6. "Level"
7. Set the desired intensity.
The air flow and air distribution are controlled au‐
tomatically depending on the selected intensity.
The selected intensity is shown on the climate
control display.
Seite 212
CONTROLS
Climate control
212
Online Edition for Part no. 01402779113 - II/19
To Next Page
Loading...
