Model 670C Berkeley Nucleonics Corp. 77 of 96
100 %
50 %
0 %
Period
Both Rise and Fall times follow the 10-90 format and are taken into account so that the above model holds
true.
With Pulse Delay you can control the initial delay you want your pulse to have.
Square type parametric waveforms are closely related to Pulse type parametric waveforms, having in
common all parameters except Pulse Width/Duty Cycle, as they aren’t available. These differences arise
from the fact that a Square waveform always has a 50% Duty Cycle.
The Sweep type parametric waveform is one of the types that doesn’t have Auto Calc, as such you’re free
to customize both Length and Sampling Rate.
It has three characteristic parameters: Start Frequency, Stop Frequency and Sweep Mode.
While Start and Stop Frequency are straightforward, as their names imply, Sweep Mode instead lets you
change between a Linear and a Logarithmic sweep.
To change the Sweep Mode, you only need to tap on the Sweep Mode toggle switch, as shown in the
image below.
To Next Page
Loading...