Pedals
IMPORTANT! Left and Right pedals are NOT THE SAME.
Fitting them on the wrong side will break the crank. The
pedals should go in easily; if not STOP! Check you have
the correct pedal and check you are screwing in straight
not at an angle.
If you have any bike grease, apply a little to the thread of
each pedal before you attach them.
“R” is for right. This goes on the CHAIN SIDE of the bike.
“L” is for left. This goes on the OTHER SIDE OF THE BIKE.
• Fit the the“R” pedal to the right side crank arm with
your ngers and turn gently in a clockwise direction.
• Once it is loosely tted tighten securely with a 15mm
spanner.
• Fit the “L” pedal to the LEFT side crank with your
ngers and turn gently in an anti-clockwise direction.
Once it is loosely tted tighten securely with a 15mm
spanner.
LEFT RIGHT
LEFT
RIGHT
LEFT SIDE
To Next Page
Loading...