NEUTRAL
REVERSE
1
FORWARD
A
P–16622
Keyless Controller Shown
C
P–16616
1
2
3
4
331/331E/334 Excavator
Operation & Maintenance Manual
19
STARTING THE ENGINE
12.
Keyless Start (Keyless Controller)
Perform the PRE–STARTING PROCEDURE Page 16.
Put control levers (Item 1) [A] in the neutral position.
Move the engine speed control to low idle [B].
Press ENTER CODE Button (Item 1) [C]. The display will
become lighted and there will be two short beeps. CodE will
appear on the LCD.
Use the keypad (Item 2) [C] to enter the password. For
each digit that you enter, a dash will appear on the LCD.
(You have 40 seconds to enter the password or the process
will abort and you will need to start over.) If the password
was entered correctly, there will be one long beep.
NOTE: If the password was incorrect there will be
three short beeps and “Error” will appear on
the LCD. Press the ENTER CODE Button again
and start over. After three failed attempts, you
must wait three minutes to try again.
Press the START Button (Item 3) [C] and hold it until the
engine starts.
Do not engage the starter for longer than 15
seconds at a time. Longer use can damage the
starter by overheating. Allow starter to cool for
one minute before using starter again.
I–2034–0700
Press the STOP Button (Item 4) [C] to stop the engine.
Password Lockout Feature
See SYSTEM SETUP AND ANALYSIS, Page 57 for
Password Lockout Feature.
Keyless Controller Shown
B
P–16615
To Next Page
Loading...